Digiprog 3 V4.94 Update Service+ software installation steps

In this blog chinaobd2.com will offer you Digiprog 3 V4.94 Update Service and show you how to install Digiprog iii V4.94 software step by step! If you have DP3 clone V4.88 or lower version, check below:

Get V4.94 Digiprog iii update software service here:

https://www.chinaobd2.com/wholesale/newest-digiprog-3-v494-update-software.html

For Serial Number 590C8F0E0000 24CC65070000 and AFD68C070000 check below:

https://www.chinaobd2.com/wholesale/digiprog-3-v488-update-service-for-serial-number-590c8f0e0000.html

Note:

1. Do not update the Digiprog 3 online when you use;
2. Disable any anti-virus software on your computer before running an update;
3. Make sure your computer will not become standby status when updating. Computer power must be well connected. Update will take 15-20 minutes;
4. Please confirm the update file is complete as display below, or will cause blue screen.

How to install V4.94 Digiprog iii software?

Copy and paste Digiprog 3 patch and update video rar to desktop, then extract them and all files in both folders

Mount on desktop, right click “Properties”

Click “Power”

Set “Turn off monitor” to “Never”

Set “Turn off hard disk” to “Never”

Set “System Standby” to “Never”

Set “Wait” value to “9999” minute

Connect DP3 mileage correction tool with computer via USB cable

Wait the system to detect driver

Found new hardware wizard

Select “Install from a list of specific location (advanced)”, click “Next”

Browse file to C:/Document and Settings/Desktop/Digiprog3-4.94 update video/CDM 2.08.30 x86WHCL Certified

Click “Next”

Click “Finish” when driver is installed

Install hardware wizard

Select “Install from a list of specific location (advanced)”, click “Next”

Click “Next”

Click “Finish”

Open 81C62817000-v4.94patch folder on desktop

Open Digiloader1 then click “Select the port and click me” button

Then open My Computer>>Manager>>Device Manager>>Ports>> USB Serial Port (COM4) to check COM Port is set to COM4

Set COM port to “COM4” and filename “Digi1 bin”. Click on “Select the port and click me” button

Message say Process end. Click “OK” to complete it.