How to use SKP-900 to program new keys of Ford Mustang?

I am a full time car mechanic, I used SKP-900 Key Programmer to test remote key for 2014 Ford Mustang. I think it’s useful and now writing to record the detail operation procedure.

Vehicle model: 2014 Ford Mustang

Equipment: SKP-900 Key Programmer

Here is the detail steps I followed:

Step1: Connect SKP-900 Key Programmer to the car, and turn it on, enter” SYSTEM SELECTION” and choose” IMMOBILIZER SYSTEM” (picture as follow)

Step2: Insert the car key into keyhole, and turn to the position “ON”, it will appear a new interface (picture as follow), just click “Yes” to continue.  communicating pls wait…

Step3: Clicking “DELETE KEY” when it enters into “FUNCTION SELECTION”

interface (picture as follow). Choose “Yes” to continue.

Step4:And click ”Yes” again to continue when the interface appears. (picture as follow)

Note: It may spend you about 10min waiting for the program.

Step5: After waiting for a long time, it pops out the message” INSRT THE 1^ST KEY,TURN IGN ON AND WAIT FOR 5 MIN”. Operating according to what it said and you would find that the light on (pictures as follow). Finally, choose” YES” to finish this step.

Step6: After the interface as follow appears. Insert car key again and turning the ignition on, you will find that the light on and off for a while.

Step7: Click ”No” to finish all procedure and go back to the main interface. Finally, try to test whether the remote key can work or not.

Congratulations! It’s working now!

Skp900 program keys of 2014 Ford Mustang- SUCCESS!

Konw more about skp-900 program key for car model,pls read below articles:

SKP900 for Key Copy on Ford Edge

SKP900 add smart key for Ford Mondeo 2008

SKP900 key programmer program Land Rover key

Save