How to read & write Cummins CM2350 data via IDUTEX TS910 PRO?

How to use IDUTEX TS910 PRO to read & write Cummins CM2350 data successfully in step by step procedure.

 

Tools to use:

IDUTEX TS910 PRO full set ( tablet + VCI box).

USB cable

Jumper

Cummins CM2350

 

First introduce the jumper of the Cummins CM2350.

This is engine port.

This is OEM port.

 

Procedure:

Open IDUTEX TS910 PRO software

Tap “Vehicle Diagnosis”, then “ECU Programming”.

Tap “Flash Write Jumper”.

Find out the Cummins CM2350 jumper diagram.

Power cord is connected to pin 1 (by following the diagram).

Ground wire access to pin 73.

Ignition key line is connected to pin 5.

CANL line is connected to pin 22.

CANH line is connected to pin 46.

Jumper is completed.

Use the main cable to connect to the VCI, and connect to the IDUTEX TS910 tablet.

Use the power adapter to supply power to the Cummins CM2350

and the VCI.

Tap “Vehicle diagnosis”, then “ECU programming”, then “Cummins system”.

Tap ” Automatic Detection of Cummins Diesel Engine”.

View Cummins CM2350 information, tap “Confirm”.

Tap “Read computer board data”.

Tap “Confirm”.

Tap “Read”.

The system automatically backs up the data that needs to be written, tap “Confirm”.

Reading data in several seconds.

Tap “Confirm” to write the data.

Tap “Write computer board data”.

Select “Package set”.

Tap “Automatically match the original data”.

The system automatically selects the brush to write data.

This is computer board information, packet information comparison.

Tap “Write”.

Back up vehicle configuration information before writing.

Writing succeed.

Writing succeed, please turn off the ignition.

please turn on the ignition

Job is done.

Exit IDUTEX TS910 software.