CONDOR XC-007 VS Italy cutting machine VS Clone cutting machine

CONDOR XC-007 VS Italy cutting machine VS Clone cutting machine

As an experienced locksmith, I am often asked which one key cutting machine is best, is the expensive one is good and the cheap one is not working? It is hard for me to answer, each tool has their pros and cons, which one is best, it depends on your needs and budget, in the following table, and I do comparative analysis on three cutting machines from several aspects.

Comparison Points	CONDOR XC-007	Italy cutting machine	Clone key machine
Machine structure	Poured by total aluminum	Poured by total aluminum	Made of plate, easy to deform
Transmission	Able to drive three-axle, apply ?TBI Ball Screws made in Taiwan	Able to drive X- axle and Y-axle, apply Ball Screws	Able to drive three- axle, the belt drive the parts to move.
Main axle motor	great strength, brushless motor	great strength	Less strength, apply carbon brush motor
Fixture	Available to replace fixture, with 2 set standard configuration: inner groove and outer ?groove, a set of Ford fixture for option	Can replace fixture, 5 set of fixture	Some ones is not able to change fixture, and neither can’t update, support more kinds of fixture.
Requirement to cutting tool	Has no requirement to cutting tool	With special cutting tool	Most cutting tool can be used
Probe, milling cutter dual set	With Probe, milling cutter dual set	With Probe, milling cutter dual set	Most are not dual set, it needs to replace when study and produce, it costs too much time
Key data base	Available with key database, can update online	Available with key database, can update online	No available with key database, only with coding database of lock blank
After-sales service	With special technical support, support remote assistance	With Original Factory service	If it is hardware problem, the user has to send back to the seller, if it is software problem, the seller can’t support solutions.