XENTRY Diagnosis VCI (C6) XENTRY XDOS V3.0.1.508 update and configuration

XENTRY Diagnosis VCI (C6) XENTRY XDOS V3.0.1.508 update info & guide, and if you use your own Xentry software you need to configure by following our tutorial.

 1.Vxdiag Benz C6 Xentry V3.0.1.508 update info:

1). Release XENTRY Diagnosis VCI (C6) driver and the compatible software XENTRY XDOS 2018.05

2). Release XENTRY Diagnosis VCI (C6) driver for XENTRY XDOS 2018.05

2.XENTRY XDOSV3.0.1.508 update guide:

1.Upgrade newest VCX firmware version 1.4.4.0.

2.Upgrade newestDoIP firmware version 1.3.1.

3.Setup BENZ C6 driver

You need:

XENTRY Diagnosis VCI (C6) + XENTRY XDOS V3.0.1.508:

Reason: VCI + Xentry software, you can directly use after receive the package.

3.Vxdiag Benz C6 XENTRY XDOSV3.0.1.508 configuration:

* If you use your own Xentry software you need to configure by following our tutorial.

Remark: If the XENTRY XDOS V3.0.1.508 is setup automatically, you are required to configure the Xentry Diagnosis VCI by following the bellow procedure.

1. configure the Xentry Diagnosis VCI, select ” XENTRY Diagnosis VCI”

2. Click on “Configure”.

3. Click on “Continue”.

4. Click on “Continue”.

5. The “StartKey” is not found, click on “Manually” to enter “StartKey”.

6. Save key and click on “Application and Continue”.

7. Click on “Application and continue”.

8. Configuration complete, click on “Exit”.

9.Configuration complete, reboot the PC.

Configuration succeed and the XENTRY Diagnosis VCI is connected ok, then this icon below will display.

www.chinaobd2.com