Cummins Insite Manual: How to clear fault codes

Cummins Insite 8.1 crack is verified to clear fault codes without any issue.

How to clear fault codes on Cummins Insite Pro:

After you connect to the ECM with Insite, click the “Fault Codes” tab on the left.

After the codes are displayed, highlight one of them & right-click on it.

Select “Erase all Faults” and follow the instructions.

You will be asked to turn the key off, and click a button, then key on

How to clear DTCs (check engine light) on Cummins Insite without a code reader:

NOTE: Depending on which flash is on your PCM, there is a chance that this procedure will not work. In that case, it is best to use an OBD-II scanner (e.g. NEXIQ VXTRUCKS V8 USB Link) to clear the codes.

Put the key in the ignition with doors closed.

Cycle the key FIVE times from the OFF position to the RUN position without cranking the engine. Leave in the RUN position on the FIFTH cycle. Note: The RUN position is TWO clicks while the ACCESSORY position is only ONE click.

*Example: KEY IN (OFF) – RUN – OFF – RUN – OFF – RUN – OFF – RUN – OFF – RUN

This will clear any DTCs that are currently active or stored in the PCM.